Forums :: Resources :: Features :: Photo Gallery :: Vintage Radio Shows :: Archives :: Books
Support This Site: Contributors :: Advertise


It is currently Dec Fri 15, 2017 2:59 pm


All times are UTC [ DST ]





Post New Topic Post Reply  [ 2 posts ] 
Author Message
 Post subject: I found this helpful for eleminating Tube Amp Heater Wiring
PostPosted: Oct Sat 21, 2017 11:02 am 
Member

Joined: Jun Wed 22, 2016 6:39 pm
Posts: 52
I found this video was helpful to me:Tube Amp Grounded Heater test
https://www.youtube.com/watch?v=ibJuMAy ... ploademail

This helped me, I hope it helps someone else.


Top
 Profile  
 
 Post subject: Re: I found this helpful for eleminating Tube Amp Heater Wir
PostPosted: Oct Sun 22, 2017 12:25 am 
Member
User avatar

Joined: Nov Sat 26, 2011 4:09 am
Posts: 8088
Location: Texas. USA
If the person had a floating heater supply then, sure, the heater supply must be grounded. Or, more specifically, referenced to some voltage in the amp. Otherwise, with no reference, the heater to cathode voltage can, and will, be "anything" since it's unspecified. In particular, it'll float around till heater-cathode leakage current finds a path somewhere. That's where the hum comes from and it's not all that great for the heater insulation either.

Sometimes hum can be reduced by referencing the heater supply to a voltage more positive than the cathode. In other cases it's necessary to elevate the heaters even more to keep heater-cathode voltage within spec, which is a solid clue that the heaters must be referenced to the amp's supply because, if not, what's the heater-cathode voltage? The most common reference is ground.


Top
 Profile  
 
Post New Topic Post Reply  [ 2 posts ]  Moderator: Chuck Schwark

All times are UTC [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests



Search for:
Jump to:  


















Privacy Policy :: Powered by phpBB