 
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
decoradioman
|
Post subject: Taylor T21 tube testing  Posted: May Thu 03, 2012 7:26 pm |
|
Joined: Nov Mon 03, 2008 10:47 pm
Posts: 391
Location: Little Rock, AR
|
|
Anybody know the test settings for this tube on a TV-7A/u? Thanks
|
|
| Top |
|
 |
|
Jim Cross
|
Post subject: Re: Taylor T21 tube testing Posted: May Fri 04, 2012 7:36 pm |
|
Joined: Jan Thu 01, 1970 1:00 am
Posts: 661
Location: Orlando, FL, USA
|
|
The Taylor T21 is essentially a 6L6G on a 6pin base. Taylor omits the beam-forming plates on their basing diagram, but they ARE there. The T21 has a 6B basing, the same as a type 41 (except the 41 it a true pentode..) So...
Set up the filament and selector switches like a type 41, then the bias shunt, and range switches like a 6L6. Test buttons and minimum as per 6L6 also. This yields...
T21 6.3 GR4-2350 23 - D 3 40
Jim Cross
|
|
| Top |
|
|
Who is online |
Users browsing this forum: hawaii.ken and 3 guests |
|
|
