Hi friends, We have a Perpetuum Ebner Rex4A turntable that was in bad need of help. We've got it rebuilt and ready to roll, with one exception. We carefully diagrammed where everything goes when it was disassembled and then put the drawing some place safe where we'd know where it is. You know that "safe place" where we all put things which translates to "never to be seen again"? Sooooo, we need some help reassembling. The schematic for this unit does not show wiring. The red wire is the 110V that goes to the motor and needs to be reattached to the terminal board that holds the start-up capacitor and the limit resistor. Can someone help and remind where it needs to be attached?