Forums :: Resources :: Features :: Photo Gallery :: Vintage Radio Shows :: Archives :: Books
Support This Site: Contributors :: Advertise


It is currently Oct Fri 19, 2018 3:06 pm


All times are UTC [ DST ]





Post New Topic Post Reply  [ 3 posts ] 
Author Message
 Post subject: Ballast tube project on K49C
PostPosted: Jan Wed 03, 2018 9:07 pm 
Member

Joined: May Sat 07, 2016 12:46 am
Posts: 85
Hi I'm working on a Ballast Tube K49C.. which I would like to convert to solid state.. I ruff up two drawings on the project and would like to see if I missed anything, or check my math.. before I pull out my iron..The diagram was found on the internet, and then plugged in the math......Thanks for the help


Attachments:
a2.jpg
a2.jpg [ 57.03 KiB | Viewed 246 times ]
b2.jpg
b2.jpg [ 31.21 KiB | Viewed 246 times ]
Top
 Profile  
 
 Post subject: Re: Ballast tube project on K49C
PostPosted: Jan Thu 04, 2018 8:55 pm 
Member

Joined: May Sat 07, 2016 12:46 am
Posts: 85
also my have to drill small holes in the Cap to vent heat


Top
 Profile  
 
 Post subject: Re: Ballast tube project on K49C
PostPosted: Jan Thu 04, 2018 8:55 pm 
Member

Joined: May Sat 07, 2016 12:46 am
Posts: 85
also my have to drill small holes in the Cap to vent heat


Top
 Profile  
 
Post New Topic Post Reply  [ 3 posts ]  Moderators: Marcc, Norm Leal

All times are UTC [ DST ]


Who is online

Users browsing this forum: Camposyka, reset, SHenion, thunderbird281 and 13 guests



Search for:
Jump to:  
























Privacy Policy :: Powered by phpBB