so, all the tubes are good, the plug and cord are good, pilot lamp is good, power switch is good, but no light-um up....new filter cap. r15 (power supply section) is only 2.7 ohms (should be 82), and r14, same section is 1200 which is correct. Ohms check across the power plug with switch on reads about 124 ohms...print does not give that value...Elements of Radio servicing says an AC/DC should be no more than 400 ohms there. Would r15 being low cause a problem? It is across the pilot lamp. http://www.nostalgiaair.org/PagesByMode ... 018832.pdf
Just a bit puzzled with this. I'm sure it is some little thing.