Forums :: Resources :: Features :: Photo Gallery :: Vintage Radio Shows :: Archives
Support This Site: Contributors :: Advertise

It is currently Feb Wed 26, 2020 5:46 pm

All times are UTC [ DST ]

Post New Topic Post Reply  [ 1 post ] 
Author Message
 Post subject: Keeping nuts out of your Atwater Kent Power Supply
PostPosted: Dec Sun 27, 2015 6:34 pm 
User avatar

Joined: Dec Thu 29, 2011 8:45 pm
Posts: 1727
Location: York, PA
Some things I have to learn the hard way:
When removing and/or installing the dozen or so 5/16" nuts on the terminal board of AK power supplies, make a barrier with wide painter's tape. This will provide a means to stop the nuts from falling down under the board or into the power supply if youve melted out the tar and installed new components into the empty cavities.
Those nuts have a way of getting lost in there!

DSC02861.JPG [ 141.5 KiB | Viewed 1192 times ]

Bill W
Post New Topic Post Reply  [ 1 post ]  Moderator: Chuck Schwark

All times are UTC [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

Search for:
Jump to:  


Privacy Policy :: Powered by phpBB