Forums :: NEW! Web Resources :: Features :: Photo Gallery :: Vintage Radio Shows :: Archives
Support This Site: Contributors :: Advertise


It is currently Oct Fri 22, 2021 11:34 am


All times are UTC [ DST ]





Post New Topic Post Reply  [ 2 posts ] 
Author Message
 Post subject: Cal Source and Movement Checker
PostPosted: Dec Fri 18, 2020 8:41 pm 
Member

Joined: Jun Sat 09, 2007 8:14 am
Posts: 5103
Location: Melbourne, Florida
I use this little klooge for calibration and to check meter movements. It's built up on a piece of wood with a small piece of masonite for a front panel. There are two binding posts and two pin packs. The pin jacks are convenient for a DMM when using it as a calibration voltage source. To check a movement, connect a DMM in series with the movement. Start with the pot fully counterclockwise.

A ten-turn pot makes it easier to set precisely. The 4.7 K limits the current. The LED isn't necessary but helps not leaving it on and draining the battery.

Having something like this around is a lot handier that having to set up something each time you need it.

RRM


Attachments:
Cal Source.pdf [157.43 KiB]
Downloaded 147 times
Top
 Profile  
 
 Post subject: Re: Cal Source and Movement Checker
PostPosted: Dec Fri 18, 2020 9:36 pm 
Member

Joined: May Tue 30, 2006 4:46 pm
Posts: 10932
Location: Santa Rosa, CA
The next step would be to add a Bandgap Reference for really accurate voltages.

https://www.analog.com/media/en/technic ... 6657fd.pdf

Rich


Top
 Profile  
 
Post New Topic Post Reply  [ 2 posts ] 

All times are UTC [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests



Search for:
Jump to:  


































Privacy Policy :: Powered by phpBB